Bell has been setting the bar on helmet development in the off-road world since 1975. They set trends by finding solutions to make anyone in a Bell helmet as safe as possible, allowing them to perform at their best. It is no surprise that the Bell Moto-10 is the most advanced lid to come out of their factory with features designed to make other brands scramble to catch up.
Not to brag too much, but we feel that our 3D printed chin mounts are worthy of being attached to the Bell Moto-10. They are designed to extend far enough from the chinbar to allow the camera to have plenty of “tip back” angle for when you are standing on your pegs. This tip back angle allows you to align the camera with your eyeport on the helmet to get a parallel view of the terrain - a little of the bike, a little of the horizon - you know, the perfect perspective.
We have found that the chin mount location is optimal for a POV camera for a couple of reasons. First, audio pickup is much better. With the camera in front of your mouth you can clearly hear yourself swearing as your buddy pulls away or laughing when the same buddy gets stuck in the rut you warned him about 10 minutes earlier. Second, your camera does not stick out where a tree branch can knock it out of alignment, or worse, send it tumbling into the weeds or off the side of a cliff. While there is a chance that you may hit the camera if you crash, we have found that most people do their best to turn their head to avoid a face full of dirt whenever possible. Even if you do go chin first into a rock, we can promise you that the mount will not break.
That is a bold statement, one that we back up with a lifetime warranty. Hassle free, just let us know and we will get a new one out to you.
Our chin mounts are made of Thermoplastic Polyurethane which has rubber-like properties. This allows us to make mounts that are flexible enough to twist into a pretzel, but strong enough to keep your camera pointed exactly where you aim it without inducing vibration even at full boogie over rocky terrain.
We designed the mounts for maximum convenience, not just durability. The GoPro mounting screw is on the opposite side making it easier to access the battery side door. We also have notches to help you get a consistent tip back angle every time. You should be able to fit most cameras from GoPro to DJI Osmo and everything in between on our custom-fit mounts.
We took advantage of the design of the Bell Moto-10 and made our mount extra wide for maximum adhesion, but it is still designed to be removable without leaving any residue on the helmet. We do offer replacement 3M mounting tape if you want to reattach it later. That said, you will need to also pick up some Gorilla Clear Grip Glue (say that five times fast) to adhere the tape to the mount.
If you were wondering if our mounts work with the Media Mod, the answer is yes, so get out there and make some epic content.
For samples of what kind of perspective our mounts can give you, check out our Instagram, YouTube, or for the youngsters out there, Tik Tok channels.
In the box:
- Chin Mount for the Bell Moto-10.
- Mounting screw
- Sweet WannaBes stickers.
- Alcohol Pad
Optional Accessories Available For Purchase